EC21 Product Catalogs - value spring

Performance Test System of Floor Spring

20241019

value according to EN 1154:1997+A1:2006,ANSI/BHMA A156.4:2019 (As shown in Figure 1) and test method and report for QBT2698-2016;; 6． set another open direction and repeat the test Specification:

Professional FI Manufacturer for Power Distribution Network Intellegent Wireless Office System

20240520

value≧5A，CT can supply meet the indicator power requirement  Sampling accuracy: I<10A±1%，I>10A±2%  Sensor factory automatic calibration, to ensure consistency；  intelligent motor c

Digital Test Hammer

20240430

spring stiffness: 785 N/m The static friction of pointer slider 0.65N±0.15N Radius of spherical tip 25mm±1mm The average rebound values on steel anvil 80±2 Data storage capacity 200 standard compo

KRD10 Hydraulic Vertical Shock Test System

20240416

values, integrated IPS-2000 shock control & measuring system can accurately execute the shock test Multi-track Guide Posts: combined with good lubricity and noise free hydraulic balance lifting syste

20KN Electronic Universal Testing Machine Tensile Testing Equipment

20220901

value ±1% / the value ±0.5%Load SensorBasic configuration sensor max load: onePower Supply220V , 50HZ or according to the requirementCompany ProfileWe GBPI is a professional manufacturer focused on

Crease and Stiffness Tester

20180628

spring back) is important in the performance of cartons on high speed packaging machines and when manual folding. The value of crease stiffness is technically important in the folding of carton blan

Enviclone IEC 62782 Photovoltaic Modules Solar Panel Cyclic Dynamic Mechanical Load Test Machine

20240111

values in different areas of the component; Industrial computer control and recording, large data storage capacity; Pressure, tension, holding time, number of cycles, cycle frequency, and current siz

EHS Shore Durometer Hardness Tester Unit

20240313

values are obtained with a thinner specimen. （4）The lateral dimensions of the specimen shall be sufficient to permit measurements at least 12.0 mm from any edge. 2． Test Mode There are three ki