Sell Thermal shock test chamber

Thermal shock test chamber

This chamber is designed to test samples for thermal impact of high and low temperatures by sharply dropping, in order to detect not only defects, but also to determine the operational durability and reliability of samples. Basket quickly moves from the cold to the hot zone and back, from one zone to another, is no more than 10 seconds.

Technical specifications:

Model   HD-CTS2-01J  HD-CTS2-02J  HD-CTS2-03J
Basket volume  48 L  120 L  190 L
Basket dimensions (D*W*H)  300*450*350 mm  500*600*400 mm  600*700*450 mm
External dimensions (D*W*H)  2250*1300*1950 mm
(approximately)  2750*1200*2000 mm
(approximately)  2350*1640*2640 mm
(approximately)
High temperature area  Temperature exposure range  +60...+200℃
  Preheating temperature upper limit  200℃
  Heating time  R.T...+200℃: 40min (approximately);
Low temperature area  Temperature exposure range  0...-75℃
  Precooling temperature lower limit  -75℃
  Cooling time  R.T....-70℃: 60min (approximately)
Basket   Temperature range  -65...+150℃
  Temperature fluctuation  ≤1℃
  Temperature deviation  ≤±2℃
Conversion time  ≤10 seconds
Temperature recovery time  ≤5 min.
Material
Shell material  Cold rolled sheet steel, spray plastics on surface
Internal material  Stainless steel
Thermal insulation material  Polyurethane foam +glass wool
Refrigeration system
Refrigeration mode  Mechanical compression, two-stage refrigeration
Cooling mode  Water cooling
Compressor   Imported compressor
Temperature sensor  Pt100
Controller   Programmable logic controller, 7’’ LCD touch screen
Power supply  AC380V 50Hz, Three-phase four-wire + earth wire