Sell Wireless Security Alarm System

Part1 Key functions
1. Zone display: LED digital display, indicates zone of intrusion
2. 12 seconds voice record function
3. 6 zones capability: pre-stored alarm event such as fire-alarm, intrusion, gas leakage.
4. 6 groups lines alarm automatically: the main unit will advise alarm status and also display the alarm zone
5. Power off protection: all inputted data including pin codes will not be affected in a power failure
6. Separate arm and delay arm function
7. Recognise alarm events: can inform through telephone the cause of alarm i.e. intrusion, fire, gas or smoke by number of beeps.
8. Remote access function, remote arm,disarm, start up siren etc
9. Easy to add on additional detectors if required

Anti-tamper function: the alarm will activate if the telephone wire is cut off

Code protection: all actions cannot be processed without the correct code; you can change the code any time.
Dial to extension number, or extension number dialing out for alarming

Standby batteries

Network function, the first telephone must be the monitor center

Part2 Main unit installation

1. Note: the main unit should be easily accessible, there should be a power socket available and also a telephone line
2. Connect the telephone line cord: Connect all the lines as in figure below (connect telephone line first and then connect power), then install batteries into the compartment
3. Install detectors: place all detectors as desired whilst making sure that there is no interference of signal from other electrical equipments
4. The main unit and wireless detectors should not be near to metal objects, or it will shorten the launch and receive distance
5. After main unit installation, please test the system. Under disarm status, the telephone can be used normally
Main unit installation figure: