Tire Inside Paint Agent Description:
Inside Tire paint agent is inside tire demolding agent
without fillers. It contains reactive silicone polymer. This product can
provide good sliding performance between the bladder and the green tire and
demoulding performance after vulcanization. Green Tire In-Spray has good
exhaust performance despite being filler-free. After vulcanization, the inside
of the tire is bright and smooth, and the inner liner will not have the common
negative effects of silicone oil products. This product is used in small amounts,
dries quickly, and is ready for use.
Technical
data (Tire Inside Paint Agent)
Composition:
Grey-black emulsion of reactive silicone polymer
Appearance:
Gray-black liquid
pH: 8~11
Usage (Tire Inside Paint Agent):
Green tire spray liquid SIP-95WM can be diluted with
water and sprayed on the inner surface of the green tire with an atomizer or
airless spray device. It will not produce precipitation when used, but it is
recommended to stir it slightly.
Tire Outside Paint Agent Description:
Tire outside Paint Agent is a water-based tire spray liquid with rubber adhesion. It is a
liquid product sprayed on the outer surface of the tire embryo before the tire
vulcanization process. It can generate adhesion at the joint of the tire
embryo, so it does not affect the adhesion between the rubber at the joint of
the tire embryo. Tire outside Paint Agent is not easy to contaminate the mold, which extends the
service life of the mold. It can provide good exhaust and mold fluidity, so it
can reduce tire vulcanization defects. This product can be brushed or sprayed
directly, with a small amount and fast drying.Tire outside Paint Agent does not contain organic solvents. If used correctly, the
liquid in the spray gun will not clog the gun hole.
Technical
data(Tire outside Paint Agent):
Composition:
Aqueous suspension of filler, polymer and surfactant
Appearance:
Black, medium viscosity suspension
Dry
content, (10 5°C, 4h): (15.0~19.0)%
PH: 6.0~8.0
Usage (Tire outside Paint Agent):
Green tire
external spray liquid can be used directly or diluted with water, and can
be applied to the tire surface by brush or air atomizing spray gun.
It is recommended
to lightly stir the product before use or lay the packaging barrel flat, and
gently roll or shake it (make sure the packaging barrel lid is sealed).
Brush: Brush
(size and material depend on ease of use).
Recommended
spraying conditions:
Nozzle material:
stainless steel
Nozzle
size: 0.8 ~ 1.5 mm
Material
pressure: 1.5 ~ 3.5 bar
Air
pressure: 2.5 ~ 6.0 bar
After a long production
stoppage or shift change interval, the spray gun should be flushed with
gasoline or high-pressure water before use to prevent the spray liquid drying
film from clogging the nozzle. The product container or packaging barrel should
be sealed immediately after use to avoid water loss and affect stability.
Application
areas:
Tire Industry
