Buy Now

Sell Now

My EC21

Search Advanced Search

Products > lcd 5 > Hyde Science and Technology Limited | Similar Products

Your search for "

lcd 5

" in Testing Equipment found 8 Products from Hyde Science and Technology Limited, China

Inquire Now

(1-8 out of 8)

Sand and Dust Test Chamber: 50 μm Spacing between lines 75 μm Talcum powder amount 2 kg/m3～4 kg/m3 Blowing dust cycle Cycle control, can control the total test time, and can also program the blowing dust time and stop time for ...

High Low Temperature Humidity Test Chamber: 5%R.H.), ±5%(≤75%R.H.) Heating and cooling rate ≥1℃/min (-55℃～+85℃ ) Material Shell material Cold rolled sheet steel, spray plastics on surface Internal material SUS304 Stainless steel Thermal ...

Rain Spray Test Chamber: 5 mm, threaded interface, easy to change IPX5 spray volume 12.5 ± 0.625 L/min IPX6 spray volume 100 ± 5 L/min Spray distance 2.5 m Water pressure according to technical requirement Temperature ...

Walk-in High Low Temperature (Humidity) Test Chamber: 5%R.H.), ±5.0%R.H. (humidity ≤75%R.H.) Heating and cooling rate ≥1℃/min (-55～+85℃) Material Panel material Polyurethane cold storage sandwich panel, thickness100mm Shell material Cold rolled ...

Quick Temperature Variation Chamber: 5℃ Temperature uniformity ≤2℃ Temperature deviation ±2℃ Range of temperature variation -40～+80℃ or -55～+80℃ Temperature variation rate 5℃/min～15℃/min Material Shell material Cold rolled sheet steel, ...

High Low Temperature Test Chamber: 5℃ Temperature uniformity ≤2.0℃ Temperature deviation ±2.0℃ Heating and cooling rate ≥1℃/min (-55℃～+85℃) Material Shell material Cold rolled sheet steel, spray plastics on surface Internal ...

Temperature Shock Chamber (Three-zone): 50℃; Low temperature: -55℃～-10℃; Temperature fluctuation ≤±0.5℃ Temperature deviation ±2℃ Temperature recovery time ≤5 min Material Shell material Cold rolled sheet steel, spray plastics ...

Thermal Shock Test Chamber (Two Zones): 5～+150℃ Temperature fluctuation ≤1℃ Temperature deviation ±2℃（-65℃～+150℃） Conversion time ≤15s Temperature recovery time ≤5 min Material Shell material Cold rolled sheet steel, spray plastics on ...

Page 1 of 11

Go to Page Go