Custom processing: Yes Material: iron plating stainless steel
Specifications: Copper core copper open copper core open zinc core iron open Scope: Room bathroom channel
Hot-selling goods 3601 PB ET588 PB ET607 SS ET3101 PB ET3801 PB ET3905 CP ET 1. Three-bar handle lock for home use, easy to install and economical and practical 2. Life protection 100,000 times 3. Surface plating from corrosion resistance 4. Using stainless steel or iron plating material 5. Color: PB.SS.SB.AB.AC.SN 6. Specifications: copper core copper open, copper core open, zinc core iron open 7. Function: door bathroom channel this door Lock function for the insurance tongue design, configuration is as follows: configuration 60mm / 70mm (2-3 / 8 "/ 2-3 / 4") adjustable tongue. Equipped with a 57mm (2-1 / 4 ") round bend gusset plate for door widths of 35mm (1-3 / 8") to 45mm (1-3 / 4 "). Lock the commonly used maintenance 1. Newly renovated housing room contains a lot of corrosive gases, especially the doors of the paint will be distributed formaldehyde and other corrosion gases will seriously affect the life of the lock, and even corrosion locks, daily ventilation, keep the room dry 2. Remove the door surface dust and other debris, need to use a dry cloth to wipe clean, avoid using a damp cloth or acid, alkaline detergent cleaning. 3. Lock after a period of time, there may be open is not smooth Phenomenon, do not go to the lock cylinder drops of ordinary lubricants with professional lubricants drip into the lock cylinder repeatedly open several times. 4. Before installing the lock to read the instructions carefully Special note is that in the absence of paint before the opening of the paint, paint dry after the lock will be installed, do not dry in the paint on the door lock, paint the volatile gas will reduce the lock life. 1. Make sure that the slope of the oblique tongue is in the same direction as the door. When you need to adjust the direction of the door opening, pull the tongue switch piece upwards, push the inclined tongue into the lock body, rotate it 180 °, and cut the hole according to the installation paper. 2. Insert the lock body into the hole. 3. Put the inside and outside panel, so that the handle can be rotated smoothly, tighten the screws, make the key and knob turn smoothly 6. Install the gusset and button box, align the lock body, make the tongue with the smooth, tighten all the screws. Our services and requirements
