Outline
The increasing of nonlinear loads such as computer servers, power supplies, and electronic ballast results in variety of undesirable phenomena in the operation of power systems.
The most important among these are harmonic contamination, increased voltage distortion and power system voltage fluctuations. Harmonic voltage components causes rebooting, power system losses, errors, cause excessive heating machine, can create significant interference on the communication line.
The SPC can monitor and control the active condition of single phase nonlinear load like a data bank and UPS and IT server in real-time. Therefore the SPC can keep up the best power quality of network that correspond to limitation of IEEE Std. 519, AS-2279, EN61000-3-4 and BS G5/4.
Features
Smart Power Conditioner(SPC)
- Patent No.0766718 as Single Phase active power filter control device for single phase nonlinear loads
- Meet IEEE Std.519-1992
- Solve Power Quality Problems
- Parallel connection allows easy retrofit for large system
- Eliminate neutral zero sequence harmonic current
- Modular unit and rack mount expansion
Benefits
- Solve a power quality problem
- Reduction of harmonic distortion
- Reduction of peak line current
- Reduction of loss of distribution line
- Prevents overheating in neutral line
- Prevents interference, loss of data in information transmission equipment
- Prevents damage to power sensitive user equipment
- Prevents misoperation of breaker
- Guarantee safety of power system and reduce cost
- As parallel connect to power system, simple easy installing and maintenance
- Compact Design and monitoring power quality
- It is possible to select and control harmonic
Application
Load
Computer server, SMPS, Inverter, UPS, IT equipment etc.
System
Three phase four wire, Single phase 120V~400V, 30A300A
Location
Large computer server center, Data bank, Office, Apartment, Airport, Hospital etc.
Operation
The SPC is single-phase active power filter, which is, applied statistical operation and method of injection current by using DSP. SPC is composed of breaker, power fuse, surge protection circuit, sinusoid filter, capacitor and DSP controller. DSP controller is monitoring a power of non-linear load in real time, estimates the load current harmonics, then using IGBT switching devices injects same harmonic current with perfect phase opposition into the power system. After SPC filter in operation, the voltage and current waveforms of power system become pure sine wave
System Configurations
Installation Effects
- Keep up the power factor about 100%
- ITDD is kept less than 5%
- Eliminate neutral zero sequence harmonic current
- Prevents flicker and surge
- Prevents misoperation of server and UPS
- Prevents heating end damage of neutral cable
- Prevents damage to breaker, fuse, reactor, capacitor
- Prevents sensitive equipment of noise
- Increasing the load capability of the transformers
- Improve power factor and reduce system loss
- Minimize interference with other equipment
Application Case
Dimensions of SPC
|
Type
|
SPC 15
|
SPC 20
|
|
Rraing Current(A)
|
15
|
30
|
|
Dimensions
(mm)
|
W
|
483
|
483
|
|
D
|
420
|
420
|
|
H
|
220
|
220
|
